Technical

The focus in the headlamps is retractile; it means you have to pull and push the head of the headlamp in order to adjust it. Turning the head of the headlamp does not change the focus.

The light will gradually fade as batteries decline, change to new batteries when required. Headtorches will flash repeatedly to indicate low battery.

To switch between different light outputs, either press switch fully on and off within 3 seconds or half press repeatedly to cycle between modes. After 3 seconds of on or off, the product will return to the start of the cycle when next switched on. The different light functions are controlled by ILC = Intelligent Light Control Max  = Maximum output allowed by battery and LED High  = Sustainable high light output Medium  = Medium light output, medium lifetime Low  = Long term low light output Strobe  = Flashing strobe light at 10 Hz

All SUPRABEAM rechargeable products have a RED light when charging and a GREEN light when charged. All chargers switch off automatically when battery is fully charged.

Many SUPRABEAM products have several light modes. Use the lowest light mode. This is very practical as this uses less power. Also, try to switch off completely when not required or periodically during use. This allows the battery to recover and prolongs its life.

If you have a V3pro series headlamp, you will need to connect the cable to both the battery pack and the headlamp before attempting to turn it on. Please follow these instructions:  The short end of the cable has to be connected to the battery pack. The long end of the cable has to be connected to the headlamp. Make sure that you keep the end of the cable straight when connecting it. The connection can be done in one single move, without shaking or forcing the cable. Pushing the cable in an inclined position or forcing it may damage the pins inside the headlamp or the battery pack. The cable has two small feet that will fix it [...]