Usage and controls

My headlamp doesn’t turn on

2020-02-11T14:09:03+00:00October 17th, 2018|

There are several possible causes: 1. Check the contacts You may need to clean them once in a while, or make sure that there is nothing obstructing them, such as the original protection tape. 2. Check the batteries Make sure the batteries are properly placed. Follow the signs engraved in the battery pack, they show the correct position for the batteries. Check also that the tape has been removed. If you have a rechargeable battery, make sure it is charged. 3. A contact is stuck For the rechargeable battery packs, it can occur that one of the pins gets stuck inside. You may need to push it in order for it to come back to its original position. 4. Check the cable Make sure it is [...]

Keeping your torch clean

2020-02-11T14:09:14+00:00October 17th, 2018|

Make sure the torch is clean in its assembly unions, pay special attention to the union of the tail cap. Dirt on this area could impair the correct contact of the batteries.

How do I switch between the flashlight / torch Light Modes?

2020-02-11T14:09:54+00:00October 17th, 2018|

To switch between different light outputs, either press switch fully on and off within 3 seconds or half press repeatedly to cycle between modes. After 3 seconds of on or off, the product will return to the start of the cycle when next switched on. The different light functions are controlled by ILC = Intelligent Light Control Max  = Maximum output allowed by battery and LED High  = Sustainable high light output Medium  = Medium light output, medium lifetime Low  = Long term low light output Strobe  = Flashing strobe light at 10 Hz

How do I get the longest battery life?

2020-02-11T14:10:59+00:00October 17th, 2018|

Many SUPRABEAM products have several light modes. Use the lowest light mode. This is very practical as this uses less power. Also, try to switch off completely when not required or periodically during use. This allows the battery to recover and prolongs its life.

How do I connect the V3pro series cable?

2020-02-11T14:11:27+00:00October 17th, 2018|

If you have a V3pro series headlamp, you will need to connect the cable to both the battery pack and the headlamp before attempting to turn it on. Please follow these instructions:  The short end of the cable has to be connected to the battery pack. The long end of the cable has to be connected to the headlamp. Make sure that you keep the end of the cable straight when connecting it. The connection can be done in one single move, without shaking or forcing the cable. Pushing the cable in an inclined position or forcing it may damage the pins inside the headlamp or the battery pack. The cable has two small feet that will fix it [...]

Go to Top